[Swansea Hackspace] 3d print refinement - hat tip Ceri

[Emyr Morris]

I have always been disappointed with the top layer of my 3d prints

A chance discussion with Ceri came up with a suggestion of altering the
'factor' for the top layer which would squeeze out more filament - In
Slicer I altered the top layer to extrude 150% - this has resulted in a
very smooth top layer - success!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://swansea.hackspace.org.uk/pipermail/hackspace/attachments/20150629/527412a0/attachment.html>