[Swansea Hackspace] Adweeno help

[Justin Mitchell]

The files you attached are nowhere near enough to build the ino 'sketch'
included, you have to install the full Makerblock library.  only their
website is a bit clueless on how to do that properly.

Save the attached makeblock.zip file
In the arduino IDE: Sketch -> Include Library -> Add .ZIP Library
select the file and it will install it for you.

Now go and open your spider.ino file, the IDE will offer to move it to a
properly named directory, let it.

now change the #include <MakeBlock.h> to <MeOrion.h> 
and remove the mention of Servo.h (its already included by MeOrion)

it should now build correctly.



On Thu, 2016-02-25 at 14:19 +0000, Ceri Clatworthy wrote:
> Hi,
> 
> 
> I have downloaded an .INO
> 
> 
> but I cannot get it to compile,
> 
> 
> Ideally I want to use a RAMPS 1.4 
> 
> 
> I think the makerblock h/c  files are just pin defines, but not
> sure ...
> 
> 
> If anyone can help,
>  would be very appreciative. :)
> 
> 
> Ceri
> 
> 
> _______________________________________________
> Hackspace mailing list
> Hackspace at swansea.hackspace.org.uk
> http://swansea.hackspace.org.uk/mailman/listinfo/hackspace

-------------- next part --------------
A non-text attachment was scrubbed...
Name: makeblock.zip
Type: application/zip
Size: 306588 bytes
Desc: not available
URL: <http://swansea.hackspace.org.uk/pipermail/hackspace/attachments/20160226/f969af63/attachment.zip>