<div dir="ltr">If anyone wants to have a go at using this, here's the steps to get it running.<div><br></div><div>Install inkscape</div><div>Run inkscape once</div><div><br></div><div>Install inkcut</div><div><a href="http://inkcut.sourceforge.net/">http://inkcut.sourceforge.net/</a><br></div><div><br></div><div>Replace this config file</div><div><a href="https://labitat.dk/wiki/Foison_C24">https://labitat.dk/wiki/Foison_C24</a><br></div><div><br></div><div>RTFM</div><div><a href="https://labitat.dk/w/images/3/33/Foison_c24_manual.pdf">https://labitat.dk/w/images/3/33/Foison_c24_manual.pdf</a><br></div><div><br></div><div>In inkscape, select the object you want to plot, making sure it has been converted to paths</div><div>From the menu, Extensions > Cutter/Plotter > Inkcut</div><div>Make sure you have ttyUSBx selected in the device properties</div><div>Set the baud rate to match the cutter</div><div>Jam a pen into the blade holder!</div><div>Use the arrow buttons on the machine to move the head to your home position, then zero with the target button.</div><div>Switch to online mode (big green button)</div><div>'Click Plot Paths' in Inkcut</div><div><br></div><div>If you get stuck just ask, or if you have any suggestions for setting it up permanently.</div><div><br></div></div>