[Swansea Hackspace] Filament Colour
Justin Mitchell
justin at swansea.hackspace.org.uk
Mon Aug 11 09:25:02 BST 2014
Digging around the RepRapPro website, they have the source files for all
of the parts used.
https://github.com/reprappro/mendel
One set of files is all of the parts laid out in a tray, ie pack the
print bed with as many of the parts as possible so that you only do a
couple of prints to make everything.
They are slightly risky as if any one part messes up or comes unstuck it
could jeopardise the whole tray.
They also give pre-sliced gcode files, using 0.4mm layers in PLA.
Tray1 43.8 meters eta 4:53:22
Tray2 51.8 meters eta 8:54:23
So thats an estimate of nearly 14 hours, and 95m of filament.
IF it goes perfectly. (for reference, a 1kg reel is 330m)
Given that length of time, i would be tempted to just buy a set of parts
off ebay too, but your mileage may vary.
On Mon, 2014-08-11 at 07:38 +0100, Ceri Clatworthy wrote:
> Found this ...
> http://m.ebay.co.uk/itm/331268303447?nav=SEARCH
>
> This one does not say what weight it is. But £20+ for a roll of
> filliment.
> And 24 hours. ..
>
> Might be a good buy
> Ceri
>
> On 9 Aug 2014 21:21, "Justin Mitchell"
> <justin at swansea.hackspace.org.uk> wrote:
> On Sat, 2014-08-09 at 16:34 +0100, djdavies83 wrote:
>
> > One 1Kg is more than enough to print all the parts for a
> second reprap
> > isn't it?
>
> >From what i can find the Prusa i2, and Mendel 90 are about
> 0.5kg,
> and the RepRapPro Mendel is about 0.6kg
>
> So a kilo reel should be plenty.
>
> note that you will need to dedicate some serious time to
> printing your
> own, discussions i have read suggest it can take upwards of
> 24hrs of
> printing. Your choice of settings will of course affect this
> greatly.
>
>
>
>
> _______________________________________________
> Hackspace mailing list
> Hackspace at swansea.hackspace.org.uk
> http://swansea.hackspace.org.uk/mailman/listinfo/hackspace
More information about the Hackspace
mailing list