[Swansea Hackspace] Anyone got any two colour laserable acrylic spare?

[Justin Mitchell]

On Fri, 2016-08-19 at 15:50 +0100, Tim Clark wrote:
> The flow sensor is broken and should be bypassed already, but if its
> not working then the bypass may have fallen off.

to emphasize the point. make sure the water pump is running correctly
before turning the laser cutter on, as the sensor wont check for you
just now.

if you cant get the laser enabled led to light and have checked
everything else, make sure the cable that is bypassing the little flow
sensor board hasnt fallen off.