[Swansea Hackspace] PCB made on CNC Mill

[Tim Moore]

Mega Brilliant, congratulations to all involved !

:  )))))

Tim_1

On 24 November 2014 at 23:43, Justin Mitchell <
justin at swansea.hackspace.org.uk> wrote:

> On Mon, 2014-11-24 at 23:34 +0000, Graham Owens wrote:
> > Well done guys, glad you got it all sorted.  Its a nice cut you got
> > from it.  Was this your first cut or did you have a couple of attempts
> > getting the z height correct?
>
> The board wasnt terribly flat/level, so our first depth only worked in
> some places, so we ran it again a little deeper and faster.
>
> Lots of trial and error, many lessons learnt.
>
> one lesson was that a 0.9mm drill bit will obliterate standard/small
> round pads that arent connected to a track, so i have a bit more
> tweaking to do in the pcb layout or the isolation routing
>
>
> _______________________________________________
> Hackspace mailing list
> Hackspace at swansea.hackspace.org.uk
> http://swansea.hackspace.org.uk/mailman/listinfo/hackspace
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://swansea.hackspace.org.uk/pipermail/hackspace/attachments/20141125/9bf7e702/attachment.html>